I used the same gloss ivory color from the bathtub on the sink and sprayed the brackets flat black. I painted the faucets with Testors Aluminum to tone down the shiny appearance and aged them with a wash of black acrylic. I still need to add an overflow outlet, paint the drain and add a little rusty water staining.
The pipe included with the kit would have made the sink too low, so I used a spare pipe I purchased from Sussex Crafts. I need to buy smaller washers but have put one I had on hand in for mockup purposes.
It also bothered the realist in me that there was no way for the water to get to the taps. So, I added two lines of aluminum tubing from the sink to the floor. I’ll need really tiny washers for these. And, I plan to fashion little valve knobs so grandma can turn off the water in an emergency.
It’s a lovely little sink, no?
After having no luck at Lowes or Home Depot, I discovered a fine selection of tiny, thin washers at Ace Hardware. I didn’t have too much time to look around, but it just might become my new favorite store.
I added one washer to the sink bowl and drilled out a hole for the overflow. I placed a piece of black paper behind the overflow so no light would show through. I added a couple of brown paint washes but didn’t dirty it up too much…just enough to tone down the shine and make it look like it has been there awhile.
I bought a packet of miscellaneous watch parts some time ago for various projects I have planned. There are a lot of tiny, tiny parts in there!
Today, I rummaged through it to find suitable shutoff valves. I know these are typically oval, but all I could find were round ones. I drilled holes into the aluminum tubing and glued them in place with super glue gel.
Two more of the tiny washers finish the bottoms of the water pipes where they meet the floor. I bought a washer one size larger for the drain pipe, too.
